Here you can find the default IP address and the predefined access data for the user interface of the WHR-HP-G300N NFINITI HighPower WLAN router of Buffalo. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.
User Manual for Professional Firmware. AirStation NFINITI HighPower Router and Access point. 35011762 ver.02. Page 1 WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User) 4. Please connect your broadband service with a network cable (or from Hardware Setup of WHR-HP-G300N Router: cable modem) to the “INTERNET” port on the ROUTER. View and Download Buffalo AirStation NFINITI WHR-HP-G300N user manual online. Airstation NFINITI highpower router and accesspoint; airstation wireless N technology highpower router and access point. AirStation NFINITI WHR-HP-G300N Network Router pdf manual download.
User Manual For Iphone
Login data for the user interface
192.168.11.1
root
<blank>
Preconfigured Wi-Fi settings
on a sticker on the router’s case
on a sticker on the router’s case
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the Buffalo WHR-HP-G300N, you have to do the following steps for access:
- Turn on router
- Establish a connection between the device and the router via network cable or Wi-Fi*
- Open web browser
- Enter IP address in the address bar and confirm with ‘Enter’ key
- Enter username in the open interface and confirm once more
Whr G300n V2
* Make sure that your router’s Wi-Fi is activated.
This router can also be configured with the provided software.
Reset default settings
Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the Buffalo WHR-HP-G300N to its default settings, you have to do the following steps:
- Switch on router
- Press RESET button and hold for at least 5 seconds
- Device restarts automatically
- Restoration of standard settings is finished
Execute software reset
With the Buffalo WHR-HP-G300N, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
Buffalo Whr-hp-g300n User Manual 2017
After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.